Conic Pendant

The Conic Pendant is turned from a 2-inch solid brass bar stock blank, not drawn tube or pipe. The blank is cut to length, held in a lathe chuck, and turned down to the tapered conic profile. Each piece is hand-finished, then wired and assembled in our Floyd, Virginia workshop.

A fixture turned from solid stock is dense at the center and holds its profile. That matters on a 14-inch profile hung in front of a dining table or over a kitchen island, where the line of the cone is the whole design.

The photo shows one finish. The Conic is offered in Polished Brass, Satin Brass, Aged Brass Patina, Antique Bronze Patina, and Oil-Rubbed Bronze Patina; hand-finishing is done on every piece.

Specifications

• Dimensions: 2" W x 14" H
• Canopy: Ø5"
• Construction: Solid brass, turned from 2-inch bar stock
• Sockets: (1) 60W MAX candelabra-base; lamp not included
• 1 circuit, 120V
• Stem suspension
• Rating: NRTL dry location

Manufacturing Process

Each Conic Pendant is cut from a 2-inch solid brass bar stock blank and turned to profile on a lathe in our Floyd, Virginia facility. The finished cone is hand-polished or satined by hand, patinated where the finish calls for it, and sealed with clear lacquer. The fixture is then electrically assembled and tested before it ships.

Installation Notes

Professional installation is recommended because of the weight. Mounting hardware and detailed instructions are included.

Hand-fabricated in Floyd, Virginia with global materials