Camber Pendant

The Camber Pendant is turned from a 2-inch solid brass bar stock blank, not drawn tube or pipe. The blank is cut to length, held in a lathe chuck, and turned down to a teardrop profile — a straight upper stem that swells at the lower third and tapers to a narrow point at the base. Each piece is hand-finished, then wired and assembled in our Floyd, Virginia workshop.

A fixture turned from solid stock is dense at the center and holds its profile. That matters on a 14-inch profile hung in front of a dining table, where the swell of the form is the whole design. The single light sits at the bottom tip of the column, aimed at the surface below.

The photo shows one finish. The Camber is offered in Polished Brass, Satin Brass, Aged Brass Patina, Antique Bronze Patina, and Oil-Rubbed Bronze Patina; hand-finishing is done on every piece.

Specifications

• Dimensions: 2" W x 14" H
• Canopy: Ø5"
• Construction: Solid brass, turned from 2-inch bar stock
• Sockets: (1) 60W MAX candelabra-base; lamp not included
• 1 circuit, 120V
• Stem suspension
• Rating: NRTL dry location

Manufacturing Process

Each Camber Pendant is cut from a 2-inch solid brass bar stock blank and turned to profile on a lathe in our Floyd, Virginia facility. The teardrop curve is machined to specification, then hand-polished or satined by hand. The piece is patinated where the finish calls for it and sealed with clear lacquer, then electrically assembled and tested before it ships.

Installation Notes

Professional installation is recommended because of the weight. Mounting hardware and detailed instructions are included.

Hand-fabricated in Floyd, Virginia with global materials